Hinge installation method and adjustment techniques

There are basically three types of installation

1. Full cover

All cover plates cabinet door, there is a gap between the two, so that the door can be safely opened. Arm 0 mm

2. Half Cover

In this case, the two share a side door. Among them there is a required minimum total clearance. Each door covering a distance corresponding reduction in, the need for flexible hinge concealed hinge arm. The song (9.5 mm)

3. Inside

In this case, the door is in the cabinet, the cabinet side panels adjacent. It also requires a gap, so that the door can be safely opened. Requires the use of the cabinet hinge arm of the hinge is bent.

Okuma (16 mm)

Hinge Installation Tips:

1. Minimum clearance

Minimum gap that opens the door when the door side of the minimum distance required. Minimum clearance distance from C, and the hinge type door thickness determined. When the door is rounded, the minimum clearance reduced accordingly. Minimum clearance required from each different hinge correspondence table lookup.

2. Minimum clearance half-door

When the two share a side door when the total required clearance should be twice the minimum gap so that both doors can be opened simultaneously.

3. C distance

C refers to the door and the hinge cup from the edge of the distance between the holes. Each hinge maximum available C size due to different hinge models and different. C The greater the distance, the smaller the minimum clearance.

4. Door covering a distance

Refers to the distance covered door side door covering the distance.

5. Gap

Means the entire gap with the cover, the door from the outside edge of the cabinet; the half with the cover, the distance between the two doors; including the case of the side door, the door edge gap refers to the inner edge side cabinet distance.

6. Each door hinge required number

Width of the door, the door height and material quality door hinge of each door number required determinants. In practice, various factors appear as different circumstances and different. So the figure above the number specified in the hinge only as a reference. In cases is unknown, it is recommended to do a test. For the viewpoint of stability, the distance between the hinge should be as large a number.

X = the distance between the hinge (this figure, when a 19 mm thick particle board, weight 750 kg per cubic meter of hinge used when the number)